I know, toilet paper card, sounds weird huh?? LOL, well, I have made a mini scrap book using this idea, but I wanted to make a card instead. Here are a few photos of the mini scrap book.
This is the front of the mini album
Three "toilet paper rolls"LOL
Then the pictures. If you all like this it is the same exact idea as the card, you just punch holes on the ends and add the brads and rings. Pretty cute. I had photos on both sides. I made this for my Mother-n-Law :)
Ok, enough about that and onto the card.
Just use an empty roll of toilet paper:)
Now using your scoring tool or the dull side of a butter knife. Flatten out the roll.
Now cut a peice of card stock 6 3/4 inches long by 4 1/4 inches wide. Score at 1 1/2 inches and 4 1/4 inches. You are going to tape this cardstock to the TP roll.
Now tape it really well, especially the edges:)
I did not tape it well enough, so I used a peice of sticky strip to seal it closed. Now the TP roll is completely covered in the blue cardstock.
Ok, then I cut a peice of double sided pattern paper 4 inches wide by 11. I then wrapped it around the teal colored cardstock. I did not score it, I just wrapped it. I tried to scor the first one and it ripped, it is just not strong enough, but I like the look of it wrapped:)
Then just cut off what you are not using.
And againk, using sticky tape, I sealed the edge.
I cut a strip of teal 3" wide by 11 long.
Tape the edge of the teal (you did this with the pattern paper, but I did not take pictures, same idea though)
Tape it on where you want it and then wrap it around the roll.
When you get to the end, tape it real well.
cut off the excess and it is complete
I used the Cheep talk set from Stampin' Up and some gems for the center of the flowers. I also used glossy accents to adhear the flowers.
I used some Copics to make the grass, nothing special about 4 different greens and just made swooshy lines!
Ok, now for the inside. I used a peice of chipboard, (the back of a cereal box) And I cut it to 3 3/4 long by 2 1/4 wide. Yes I made a mistake in the photo, but it is 3 3/4 long:) Then you will cut two peices of pattern paper (the opposite side that you used on the front). Cut them both 3 3/4 long by 2 1/4 wide.
Tape the chip board well and adhere the pattern paper, one peice per side.
It should look like this when you are done.
I cut two teal peices of card stock at 2 inches wide by 3 3/4 inches long
I also punched out a label
I distressed the sides using the Distress Ink and my dabber:)
I added adhesive to the inner part of the label then lined it up on the chipboard stuck it down and sealed the other side as well.
This is what it should look like. The paper gets adhered over the label so it looks like a tab.
I stamped it using gingerbread chaulk ink and some colorbox red ink.The hello there is in black
I used my copic and colored in the leaves. I also used stickles clear on the wings and for the eye.
That is it!! You have a recycled card:) Enjoy!